apple samsung LG htc hundai kia renault samsung gmdaiwoo audi bmw benz volkswagen honda infinity lexus nissan toyota volvo Chrysler jeep
비밀번호 확인 닫기
스마트폰/핸드폰 거치대 > HTC > Desire > HTC Desire 액티브 홀더
스마트폰/핸드폰 거치대


513141 HTC Desire 액티브 홀더
제조회사 : HTC
브랜드 : Desire
상품명 : HTC Desire 액티브 홀더
모델명 : 513141
판매가격 : 92,400원
수량 EA
 
 
액티브 홀더
인스톨 설치형 케이블, 12V 2A 충전 아답터, Molex 타입 아답터 커넥터
 
 
  

 
상품 상세 설명
 
 
◆ 적용제품 ◆

HTC Desire

◆ 제품설명 ◆

An active holder which is to be connected inside the dashboard, this gives a discreet, neat installation without cables hanging over the interior!

You can choose to use the holder as an active holder for charging of your device only, or to connect an adapter to the Molex connector for additional features. Then you can use the holder also for power supply of a GPS receiver or other own solutions (can not be used for data communication or audio connection).

12/24 Volt. The product is E-approved. Connect the power cable with a 2 A fuse. 2 A charger. Professional installation recommended. The holder is attached onto a tilt swivel so you can easily adjust your device in order to avoid light reflection. Attach onto a ProClip Mounting Platform.

◆ Instruction ◆

1.
2.
3.
4.


Please read all of the instructions and look at the pictures before attaching the holder. Important Note: The charger unit is fused internally with 2 A automotive re-settable thermal fuse, but if an external fuse is to be installed then connect a 2 A fuse holder and fuse inline with the Red wire close to the power source. Route the cable from the holder into the vehicle dashboard and secure the charger unit in place with the adhesive tape provided. Ensure the charger unit is securely mounted behind the dashboard in a well ventilated area that does not get hot! Note: If you are connecting a GPS/Data device to the holder please ensure the charger unit is located in a position within easy reach of any GPS or charging adapters.

Route the power cable from the charger unit to the power supply source in the vehicle and connect as follows: 1. Connect the White wire to a Negative Ground connection of the vehicle or the vehicle chassis. 2. Connect the Red wire to a 12/24 Volt power supply in the vehicle that is controlled by the ignition switch of the vehicle.

Installation of the holder: 1. Loosen the screw in the center of the holder so you can remove the tilt swivel attaching plate on the back. 2. Place the attaching plate on desired position. Screw the attaching plate into place with the enclosed screws. 3. Place the holder over the attaching plate so the tilt swivel fits. Screw the holder onto the attaching plate. 4. The holder is in place.
 
 
 
 
 
상품 사용 후기
 
 
이름 : 첨부 : 파일첨부
내용 :
평점
 
 
 
 
상품 QNA
 
상품에 대해 궁금한 점을 해결해 드립니다.
번호 제목 작성자 작성일 조회